DTAForum.com - a forum for the DTA ECU

For Sale S60 and S80 ecus
S60 €600 (appox £520)
S80 €800 (approx £670)
S80 with no Aux 5 €650 (approx £560)


Contact rocar1264@hotmail.com

Used good condition Dta S60s/S80s for sale 600/800 euros plus shipping

Worked.. wrong wire position
Yes Stevie seems they are discontinued.

Used Honeywell GT-101 Hall Effect Speed sensor with 12v and always works, now wired as Diagram with 5v but did not work ... Do these work with 5V ?

Latest firmware, but sorted , Blend table is needed as per Stevie . I also noticed that for 1 injector per cylinder OP 1 - 6 only work OP 7 & 8 won't but in twin injector all OPs works .OP 1-4 are for primaries and OP 5-8 are for secondaries

Wired and tested today ... No 1 wired as Alex said but it's not good as OP4 / pin 25 is primary , OP 5/6/7/8 are secondaries No 2 Problem is that they do not work all 12 injectors, as target is reached they just swap from primary to secondary . I tried switching twin injector at 3000 rpm . So below ...

Assume Sequential Injection needs to stay active Not with that wiring. That's semi-sequential injection with the secondaries able to be blended in. If you want sequential injection, you can't blend the second set. Which do you want? I have to run 12 injector ,I used to run sequential but both Cyl i...

Assume Sequential Injection needs to stay active

HI Alex,
Yes 12 injectors
OP 4 - Pin 24 instead of OP6 - Pin 15 for secondary Cyl 1 - 6
OP 5 - Pin 16 instead of OP7 - Pin 24 for secondary Cyl 2 - 5 and
OP 6 - Pin 15 instead of OP8 - Pin 23 for secondary Cyl 3 - 4
Correct ?

Thanks

Want to wire 2jz twin injector and run semi Sequential, not sure about the secondary OPs, If OP 4 ,5 ,6 or OP 6 ,7 ,8 as shown on my diagram