B16A2 map needed

Post maps up for others to get them going in the right direction. DISCLAIMER: USE AT YOUR OWN RISK. CONFIRM VALUES!
Post Reply
Pockets
Posts: 6
Joined: Fri May 30, 2014 12:42 am
ECU Model: S40 Pro
Distributor: Watsons
Firmware Version: 62

B16A2 map needed

Post by Pockets »

Hi,

I am running an S40 that came with a Watsons kit to convert my Mini to Honda power, but the base map makes it hard to start and it runs fairly rough low down. Does anybody have a map that would help? I'm using a supplied Motorcraft powerpack instead of a dizzy but otherwise standard motor. And MAP not connected as yet, so only TPS, but I will connect same if a good supplied map uses it.
Failing which, does anybody know of a dyno in Perth, Western Australia, where the operator has ever worked with a DTA? I'm reluctant to spend a couple of grand waiting for the dyno man to come up to speed.

Thanks.
User avatar
ignitionautosport
Posts: 577
Joined: Wed Jul 27, 2011 5:30 am
ECU Model: S80 Pro
Location: New Zealand
Contact:

Re: B16A2 map needed

Post by ignitionautosport »

I know of a guy in Aus though east side I think, I'll point him here though in case.
| '94 GSR Lancer | '96 Toyota Carib 20V | '83 Toyota Starlet | www.ignitionautosport.co.nz |
swsupermoto
Posts: 81
Joined: Fri May 30, 2014 7:36 am
ECU Model: S60 Pro
Distributor: mosley rolling road
Firmware Version: 66

Re: B16A2 map needed

Post by swsupermoto »

I'm also looking for a map for this.
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: B16A2 map needed

Post by stevieturbo »

As always, work through the manual and build your own calibration.

You need to check all settings anyway.

Largely the only slightly awkward bit might be crank trigger setup ( what are you using ? )

And ignition coil setup....again, what are you using ?

Some Honda's use an inverted coil charge not too unlike "external coil amps", but not sure if it's the same.
So OEM coil may not be compatible.
jack70
Posts: 7
Joined: Wed Nov 09, 2016 8:25 am
ECU Model: S40 Pro
Firmware Version: 79,02

Re: B16A2 map needed

Post by jack70 »

i have different maps for the honda b16a2 engine. NA or turbo

send me an email
turbo6@hotmail.com

if you have a good turbo map, please send it to me !
same email adress
dreodim
Posts: 17
Joined: Sun Jul 23, 2017 2:30 pm
ECU Model: S60 Pro

Re: B16A2 map needed

Post by dreodim »

Hello everybody

I'm searching for a Honda b16a2 OEM N/A map for my s60.
I will use some custom sensors to manage the rpm and cam and a custom ignition coil from motorbike.

I only need a map to have fuel and ignition table and make a quick start to control the loom, gearbox ...etc

After that I will bring my car to a professional tunner
So I only need a base map very close to an OEM B16a2 engine

Thanks
Post Reply