Map wanted for cosworth yb 7,4/1 comp gt3582r turbo

Post maps up for others to get them going in the right direction. DISCLAIMER: USE AT YOUR OWN RISK. CONFIRM VALUES!
Roverdose
Posts: 318
Joined: Tue Aug 09, 2011 2:54 pm
ECU Model: S80 Pro
Distributor: Roverdose
Location: Stevenage
Contact:

Re: Map wanted for cosworth yb 7,4/1 comp gt3582r turbo

Post by Roverdose »

its fine if its going 40psi boost.

where in the world are you?

take 30% out of the fuel map, all over the whole map. leave the ignition where it is, you'll need more so no worries.

Drew
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Map wanted for cosworth yb 7,4/1 comp gt3582r turbo

Post by stevieturbo »

OK. Your profile doesnt state where on earth you are from, if English is not your native language that explains a little, and apologies on that front. But the more clear and concise information you can give, the easier it will be to try and help.

I know 7.4:1 is very very low for any engine these days, but it will certainly add a huge safety margin with your tuning. Most turbo engines would be over 8:1 these days, even old Cossies, and even when running silly boost.

Back to the original query then. I dont follow why you need another map, when you have had the car running for 6 years already ?
If you have just fitted 1000cc injectors, that's approximately 60% larger than you had before, assuming flow data is accurate and same fuel pressure etc.
SO just take your entire fuel map and remove 60% from it.

ie select all cells, hit F5 and -60%

That will give you a starting point. After that the engine must be mapped properly by a competent person.
Rs2000
Posts: 6
Joined: Tue Apr 23, 2013 4:47 am
ECU Model: S60 Pro
Firmware Version: 37

Re: Map wanted for cosworth yb 7,4/1 comp gt3582r turbo

Post by Rs2000 »

Thanks,i am from Norway :mrgreen: ,ignition is difficult to adjust :oops: fuel is ok to adjust thanks for f5 :D ,boost pressure target is 2,4 bar
Ignition at 3bar
4000rpm is 10

4500 ,10
5000,12
5500,12
6000,13,5
6500,13,5
700013,5


I have run the gt3071r for 6 years but I've switched to turbo gt3582r so I can not run with the same map
katana
Posts: 455
Joined: Sun Jan 27, 2013 6:08 pm
ECU Model: S60 Pro
Firmware Version: 29

Re: Map wanted for cosworth yb 7,4/1 comp gt3582r turbo

Post by katana »

I have run the gt3071r for 6 years but I've switched to turbo gt3582r so I can not run with the same map
You can if you are using MAP for load sensing! Unless you have physically changed the inlet tract, manifold, valves etc. you'll only get greater air flow with more boost! Just because it is a bigger turbo - it can't get more air through a given hole without increasing the pressure.
Rs2000
Posts: 6
Joined: Tue Apr 23, 2013 4:47 am
ECU Model: S60 Pro
Firmware Version: 37

Re: Map wanted for cosworth yb 7,4/1 comp gt3582r turbo

Post by Rs2000 »

Tuned engine finally,645bhp and 750nm at 2bar,but the tuner was not satisfied with the Interpolation
Post Reply