Wanted honda b series map urgently

Post maps up for others to get them going in the right direction. DISCLAIMER: USE AT YOUR OWN RISK. CONFIRM VALUES!
Post Reply
B18bill
Posts: 1
Joined: Sat Mar 29, 2014 3:26 am
ECU Model: S40 Pro
Distributor: Watson
Firmware Version: 44

Wanted honda b series map urgently

Post by B18bill »

I'm after a map for a b18 urgently my ecu is the s40

I'd be most appreciative
Mark_r33
Posts: 28
Joined: Thu Aug 15, 2013 5:17 am
ECU Model: S80 Pro
Distributor: DTA
Firmware Version: 66

Re: Wanted honda b series map urgently

Post by Mark_r33 »

There is a B18 map included with the SWin software.

Looks to use an external 36-1 trigger wheel instead of the original distributor mounted sensors though. It is also apparently intended for use with a supercharger, but there is no way I would use that as it is, as the pressure compensations don't seem to be active, and those ignition values look scary if to be used with a little Jackson unit and 8 pounds of boost!

What is your set up exactly? Which variant B18?
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Wanted honda b series map urgently

Post by stevieturbo »

If you know the triggers etc, it really isnt that difficult to build a map from scratch.

All sensors should be checked anyway, so that aspect is covered. Usually the only awkward part is triggering.

Do you even have the ecu wired in ? Not 100% sure if the DTA can fire the OEM Honda dizzy/coil units as I think their weird and fire on a rising edge or something.
Maybe that's just the same as treating them as inductive coils..
Post Reply