I'm after a map for a b18 urgently my ecu is the s40
I'd be most appreciative
Wanted honda b series map urgently
-
- Posts: 28
- Joined: Thu Aug 15, 2013 5:17 am
- ECU Model: S80 Pro
- Distributor: DTA
- Firmware Version: 66
Re: Wanted honda b series map urgently
There is a B18 map included with the SWin software.
Looks to use an external 36-1 trigger wheel instead of the original distributor mounted sensors though. It is also apparently intended for use with a supercharger, but there is no way I would use that as it is, as the pressure compensations don't seem to be active, and those ignition values look scary if to be used with a little Jackson unit and 8 pounds of boost!
What is your set up exactly? Which variant B18?
Looks to use an external 36-1 trigger wheel instead of the original distributor mounted sensors though. It is also apparently intended for use with a supercharger, but there is no way I would use that as it is, as the pressure compensations don't seem to be active, and those ignition values look scary if to be used with a little Jackson unit and 8 pounds of boost!
What is your set up exactly? Which variant B18?
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Wanted honda b series map urgently
If you know the triggers etc, it really isnt that difficult to build a map from scratch.
All sensors should be checked anyway, so that aspect is covered. Usually the only awkward part is triggering.
Do you even have the ecu wired in ? Not 100% sure if the DTA can fire the OEM Honda dizzy/coil units as I think their weird and fire on a rising edge or something.
Maybe that's just the same as treating them as inductive coils..
All sensors should be checked anyway, so that aspect is covered. Usually the only awkward part is triggering.
Do you even have the ecu wired in ? Not 100% sure if the DTA can fire the OEM Honda dizzy/coil units as I think their weird and fire on a rising edge or something.
Maybe that's just the same as treating them as inductive coils..