about s40 lanch control

Post maps up for others to get them going in the right direction. DISCLAIMER: USE AT YOUR OWN RISK. CONFIRM VALUES!
Post Reply
veriagolf
Posts: 1
Joined: Fri Dec 05, 2014 6:12 pm
ECU Model: S40 Pro
Distributor: internet
Firmware Version: 77

about s40 lanch control

Post by veriagolf »

i need some help with my lanch control.can someone of you send me a picture of dta s40 lanch control?i work 27 degrees on 2 bar pressure.send me a map to try it and to make some changes if i need.thanks
Rob Stevens
Posts: 1247
Joined: Thu Jul 28, 2011 4:10 am
ECU Model: S100 Pro
Distributor: None-Coil On Plug :)

Re: about s40 lanch control

Post by Rob Stevens »

bit more info might be helpful
I assume this is Turbo not supercharged?
Do you want Launch control or just start line rpm/boost build?
Do you have the launch switch fitted on the dash or the clutch?
Do you have the wheel speed sensor fitted?
Rob Stevens
Posts: 1247
Joined: Thu Jul 28, 2011 4:10 am
ECU Model: S100 Pro
Distributor: None-Coil On Plug :)

Re: about s40 lanch control

Post by Rob Stevens »

Try something like this if a car that doesn't do wheelies. If a drag bike you might like to look at the launch rpm/time option as with the front wheel in the air you can't get the speed. either way wire the pot into Ana 1 so you can set the launch rpm easily.
Attachments
Doc1.doc
(110.5 KiB) Downloaded 532 times
Post Reply