Page 1 of 1

Dash2

Posted: Sun Apr 19, 2015 12:52 pm
by mark220475
Is Anyone out there using a dash2 on a s60 with the bus can system?

If so what serial adaptor have you used, as I can't get the dash2 to connect to the computer to program the display.
And have you got the bus can program file to get the dash2 to communicate with the DTA.

Thanks
Mark

Re: Dash2

Posted: Sun Apr 19, 2015 3:53 pm
by stevieturbo
I think a couple of users here did get it to work, hopefully they'll respond

I gave up and sold it as their CAN adaptor with config file they gave me, didnt even get close to working and RT were no help at all.

Re: Dash2

Posted: Sat Apr 25, 2015 11:59 am
by mark220475
Thanks for the reply Stevieturbo

I have now configured the CAN adaptor to the ECU and all is working well.

All the information for setting it up is in there web site, but it's not that easy to find.

If anyone else needs help setting it up I have taken some screen prints with all the information on it.

Just need to set up the scaling now, so all the reads out read correct

Re: Dash2

Posted: Thu Oct 29, 2015 3:30 am
by kire
I'm using S60 with Dash2 as well. My problem is to get the oil pressure steady. In my DTA s60 it look OK, but on the DASH it's nok steady. Its a 10 bar sensor, and i choose that from the drop down list on the input for the dash.

Do you have the oil pressure correct?

Regards
Erik

Re: Dash2

Posted: Sat Jan 20, 2018 8:02 am
by stormy_be
Hi all,

I know this is an old post.
But I'm triing to connect my S100pro to a RT dash4pro display (via a DL1club datalogger).

I don't seem to be able to figure out how to set it up.
Can anyone help with the connections and settings that should be done?

Thanks,
Koen
KoenDelvaux@hotmail.com