Page 1 of 1

B16A2 map needed

Posted: Mon Oct 05, 2015 7:33 pm
by Pockets
Hi,

I am running an S40 that came with a Watsons kit to convert my Mini to Honda power, but the base map makes it hard to start and it runs fairly rough low down. Does anybody have a map that would help? I'm using a supplied Motorcraft powerpack instead of a dizzy but otherwise standard motor. And MAP not connected as yet, so only TPS, but I will connect same if a good supplied map uses it.
Failing which, does anybody know of a dyno in Perth, Western Australia, where the operator has ever worked with a DTA? I'm reluctant to spend a couple of grand waiting for the dyno man to come up to speed.

Thanks.

Re: B16A2 map needed

Posted: Mon Oct 05, 2015 11:14 pm
by ignitionautosport
I know of a guy in Aus though east side I think, I'll point him here though in case.

Re: B16A2 map needed

Posted: Sun Apr 03, 2016 1:00 pm
by swsupermoto
I'm also looking for a map for this.

Re: B16A2 map needed

Posted: Sun Apr 03, 2016 5:21 pm
by stevieturbo
As always, work through the manual and build your own calibration.

You need to check all settings anyway.

Largely the only slightly awkward bit might be crank trigger setup ( what are you using ? )

And ignition coil setup....again, what are you using ?

Some Honda's use an inverted coil charge not too unlike "external coil amps", but not sure if it's the same.
So OEM coil may not be compatible.

Re: B16A2 map needed

Posted: Wed Nov 09, 2016 4:19 pm
by jack70
i have different maps for the honda b16a2 engine. NA or turbo

send me an email
turbo6@hotmail.com

if you have a good turbo map, please send it to me !
same email adress

Re: B16A2 map needed

Posted: Fri Jul 28, 2017 4:01 pm
by dreodim
Hello everybody

I'm searching for a Honda b16a2 OEM N/A map for my s60.
I will use some custom sensors to manage the rpm and cam and a custom ignition coil from motorbike.

I only need a map to have fuel and ignition table and make a quick start to control the loom, gearbox ...etc

After that I will bring my car to a professional tunner
So I only need a base map very close to an OEM B16a2 engine

Thanks