Page 3 of 3
Re: DTA Bracket
Posted: Tue Jan 22, 2013 5:19 am
by The Zedhed
Yer I still need smaller fingers though!
I had a look through your build pics but quite a few are not loading!
Re: DTA Bracket
Posted: Sun Feb 03, 2013 5:08 pm
by katana
Hi There Zed - know you from the 200MPH forum of old - show them your dash set up if they think they're short of space! ! ! We know Velcro works but as regards security ask the guy who used it on a bike with a Motec M800 that went walkies while his back was turned!
Re: DTA Bracket
Posted: Mon Feb 06, 2017 2:57 pm
by jsstevo
Is anyone producing a bracket yet?
Re: DTA Bracket
Posted: Mon Feb 06, 2017 4:36 pm
by katana
No
Re: DTA Bracket
Posted: Thu Feb 23, 2017 10:22 am
by mefmotorsport
jsstevo wrote:Is anyone producing a bracket yet?
Yes, me!
here:
viewtopic.php?f=11&t=1260&p=12915#p12915
Martin
Re: DTA Bracket
Posted: Mon Mar 27, 2017 11:15 am
by mefmotorsport
I now have a god stock of these:
and these:
Re: DTA Bracket
Posted: Wed Mar 29, 2017 5:42 pm
by Jon K
Nice martin, but do you find the 3D printed plastic is sturdy enough? I used to have access to a 3D printer and the parts would good for mock up usually but not sure about durability.
Re: DTA Bracket
Posted: Thu Mar 30, 2017 2:10 am
by mefmotorsport
So far it seems to be adequate for this job, I have one in my own car and it has survived a rally so far which has a jump and viscous landing!
Re: DTA Bracket
Posted: Thu Mar 30, 2017 7:07 pm
by Jon K
Ha nice - yeah it could be that I am just brutal on stuff. We had the 3D printer where you had to dissolve the material from the base plate and I'd get impatent and start scraping it off with a screw driver and usually destroyed things.
Re: DTA Bracket
Posted: Sun Dec 31, 2017 6:18 pm
by PhillipM
Depends how it's printed and what with. I print loads of structural parts - in fact my rear wings are 3d printed!