Pins for a cable labelled dash?

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
molecular bob
Posts: 35
Joined: Wed Feb 22, 2012 3:50 am
ECU Model: No ECU
Firmware Version: 31

Pins for a cable labelled dash?

Post by molecular bob »

Hi All

My used s60 loom has a cable in it labelled dash, any ideas which pins it would be linked to? It is a DTA supplied loom. A quick look yesterday suggests probably 3 cores, so if I am lucky it is can and rev counter signal, but wondered if I am wide of the mark.

Can't meter it till my new one arrives, last one is a bit non functional after running it over :oops:
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Pins for a cable labelled dash?

Post by Alex DTA »

Blue is tacho, red and white are shift light.
molecular bob
Posts: 35
Joined: Wed Feb 22, 2012 3:50 am
ECU Model: No ECU
Firmware Version: 31

Re: Pins for a cable labelled dash?

Post by molecular bob »

Cheers Alex

Will check the colours tonight.

Ian
Post Reply