Generic map/running in

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Generic map/running in

Post by Alex DTA »

Daniboy123 wrote:sparrow off club gti not sure who that is on here
That's be me. ;)

I thought I had the map on my laptop, but will upload it tomorrow.
Daniboy123
Posts: 16
Joined: Sat Nov 05, 2016 9:13 pm
ECU Model: S80 Pro

Re: Generic map/running in

Post by Daniboy123 »

Great cheers Alex. All I can do is give it a go and keep an eye on my lambda readout and follow the good advice I've been given. Once ive set my crank sensor position and entered the parameters for my lambda crank it over. Make sure oil and fuel pressure are good. As soon as ive got it running, upto temp and made sure there are no leaks ill get on the road. Ive been reading that to get the rings bedded in ill need to get it under load, around 3.5k. There are some steep hills around by me which should do the trick. Short bursts and plenty of over run to keep the cylinder walls lubricated and pistons cooled. This is what I've been reading recently if there is anything else I should be thinking about or anyone has any other advice please let me know.
Post Reply