S40pro TPS problem?

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
welshpug
Posts: 130
Joined: Tue Sep 06, 2011 4:53 am
ECU Model: S40 Pro

Re: S40pro TPS problem?

Post by welshpug »

just get it mapped asap, you could be causing it damage, I certainly would not advise driving it any further than onto a trailer.

it will soon run in on the rollers at the lower load sites, by the time the mapper is hitting the higher loads itll be fine.
dyl tex
Posts: 7
Joined: Fri Apr 28, 2017 5:30 am
ECU Model: S40 Pro

Re: S40pro TPS problem?

Post by dyl tex »

welshpug wrote:just get it mapped asap, you could be causing it damage, I certainly would not advise driving it any further than onto a trailer.

it will soon run in on the rollers at the lower load sites, by the time the mapper is hitting the higher loads itll be fine.
Thanks for the advice mate, it was going to be my next question over on the 205 forums, as I wasn't sure how safe it is to carry on driving it about before a trip to the rollers.

Cheers! :)
Post Reply