Running a Viper V10 on S100

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
MSEL
Posts: 50
Joined: Sat Jul 30, 2011 3:24 am
ECU Model: S80 Pro
Firmware Version: 78
Location: Land of the Long White Cloud

Running a Viper V10 on S100

Post by MSEL »

Has anyone ever run a Viper V10 8.3 engine on an S100?

If so, I assume you had a make your own crank trigger disc?
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Running a Viper V10 on S100

Post by stevieturbo »

MSEL wrote:Has anyone ever run a Viper V10 8.3 engine on an S100?

If so, I assume you had a make your own crank trigger disc?
Dont know of anyone who has, but it wouldnt be too difficult.

What crank trigger setup does the viper use ?
Roverdose
Posts: 318
Joined: Tue Aug 09, 2011 2:54 pm
ECU Model: S80 Pro
Distributor: Roverdose
Location: Stevenage
Contact:

Re: Running a Viper V10 on S100

Post by Roverdose »

you might need a new trigger, i found this on the net...

Image

Drew
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Running a Viper V10 on S100

Post by stevieturbo »

Well they are evenly spaced.

Although a more conventional multitooth with even spacing might be easier. Just slap one onto the front pulley.

Likely need a cam sensor too ?
Post Reply