Canbus signal

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
Huxley
Posts: 39
Joined: Sat May 10, 2014 7:37 am
ECU Model: S60 Pro

Canbus signal

Post by Huxley »

Question can I have the launch control acctivated via a can signal from my Msport style steering wheel buttons via the can from my power management unit can board on a S100pro
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Canbus signal

Post by stevieturbo »

I would say that's a pretty solid no.

Unless that CAN signal goes to a controller which can open/close a set of contacts or send an earth to the ecu.

But the ecu needs that physical switch.
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Canbus signal

Post by Alex DTA »

As stevieturbo says, that's not possible at the moment.
Huxley
Posts: 39
Joined: Sat May 10, 2014 7:37 am
ECU Model: S60 Pro

Re: Canbus signal

Post by Huxley »

Cheers guys
Post Reply