S40 shift light
Posted: Wed Nov 14, 2018 4:11 pm
I saw a question on the BRF about fitting a shift light to an S40. I explained to the guy how to physically wire the lamp, the the question arose about how to get it working,so I had a look in the manual and opened up swin.
On the S40 wiring it indicates that pin 10 should be used as the shift light, this is also labelled as aux5.
Question is, there appears to be 2 ways to set the lamp, first is via Engine Config - General Engine Settings - Gear Change Light, second is via the Aux5 window.
Does one over-ride the other if both are inadvertently set. I've not used a shift light, is it just a matter of entering a value in the general settings and leave the aux5 alone?
On the S40 wiring it indicates that pin 10 should be used as the shift light, this is also labelled as aux5.
Question is, there appears to be 2 ways to set the lamp, first is via Engine Config - General Engine Settings - Gear Change Light, second is via the Aux5 window.
Does one over-ride the other if both are inadvertently set. I've not used a shift light, is it just a matter of entering a value in the general settings and leave the aux5 alone?