Page 1 of 2
dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 8:25 am
by ss77
dta p8 pro the interior map does not work well. under pressure you can play and adjust. stops at 100mp and does not go over it even if the map is long. the map sensor works. what is the setting wrong? excuse my bad english I'm from Finland.
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 9:19 am
by stevieturbo
I think we will need a translator !
Exactly what stops at 100 ? can you show a picture ?
Are you using throttle as load, or MAP ?
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 10:22 am
by Rob Stevens
Your English is better than our Finish
From what I suspect you are trying to say is that the pressure sensor is not calibrated?
Do you have a 3bar sensor and it only calibrated to 1bar perhaps.
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 11:11 am
by ss77
how the sensor is calipred?
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 11:52 am
by Rob Stevens
see attached, in this example is a 2.5bar sensor. adjust the offset so that the main display reads atmospheric with engine not running. Don't try to open 2 windows at the same time.
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 1:53 pm
by ss77
circled I had 300kps and 0.020 Still real data will not rise above 108kps even if the pressure is bigger. where's the problem?
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 2:42 pm
by Rob Stevens
Do you have a 3 bar map sensor?
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 3:02 pm
by ss77
yes
Re: dta p8 pro not working turbo
Posted: Fri Nov 16, 2018 3:09 pm
by ss77
The dta pox's own 300kpa sensor did not even try it
Re: dta p8 pro not working turbo
Posted: Sat Nov 17, 2018 5:02 am
by Rob Stevens
can you test with an airline?