Fuel supply (not starting)

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Fuel supply (not starting)

Post by Alex DTA »

1 or 0 on 36 tooth wheel
Totalnova
Posts: 23
Joined: Sun Apr 29, 2018 7:04 am
ECU Model: S40 Pro

Re: Fuel supply (not starting)

Post by Totalnova »

Cheers, I'll have a little play when I finish work.
Totalnova
Posts: 23
Joined: Sun Apr 29, 2018 7:04 am
ECU Model: S40 Pro

Re: Fuel supply (not starting)

Post by Totalnova »

Still not having any luck with this.
It says it's synchronised (goes green when turning over and says attempting to start) can anyone see anything wrong?
Image
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Fuel supply (not starting)

Post by Alex DTA »

If it's staying green, the ECU is seeing the inputs it requires.

Is it still backfiring, either out the exhaust or inlet? If so, you have fuel and spark, just not in the right place.

Upload the Zetec with no Map.map and that should have you close.
Totalnova
Posts: 23
Joined: Sun Apr 29, 2018 7:04 am
ECU Model: S40 Pro

Re: Fuel supply (not starting)

Post by Totalnova »

Thanks for the reply Alex, I did actually try the zetec with no map last night, I'm thinking I might have my injectors cleaned as they've been sitting a few years, just trying to cross things off the list.
aleksanderk
Posts: 68
Joined: Fri Feb 01, 2019 4:36 pm
ECU Model: S80 Pro
Firmware Version: 6500

Re: Fuel supply (not starting)

Post by aleksanderk »

Did you ever get the car running?
Post Reply