There is a mistake in the DTASWin engine configuration
Go to "General Engine Settings". Then "Teeth BTDC" change from 1 to 2
DTA S60 start problem
Re: DTA S60 start problem
it's already set to 2
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: DTA S60 start problem
Go to Display and Test Functions -> Crankshaft Oscilloscope.
Gather the scope, and post the image here.
Gather the scope, and post the image here.
Re: DTA S60 start problem
Hello I have already put an image of the oscilloscope on page 1. I redo one today just in case.
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: DTA S60 start problem
Sorry, I meant when it's running.
It sounds like there are signal issues when running.
It sounds like there are signal issues when running.
Re: DTA S60 start problem
Hello
Here are two crankshaft oscilloscpobe taken at the moment.
The first engine stopped and the second engine turned.
There is a signal problem I think ...
thank you in advance
Here are two crankshaft oscilloscpobe taken at the moment.
The first engine stopped and the second engine turned.
There is a signal problem I think ...
thank you in advance
Re: DTA S60 start problem
good evening
The problem was found, I did not connect the case to ground on the external connection of the case.
I thought it was to fix it and not a mass.
Good night
The problem was found, I did not connect the case to ground on the external connection of the case.
I thought it was to fix it and not a mass.
Good night