Page 2 of 2
Re: DTA S60 start problem
Posted: Thu Mar 14, 2019 1:48 pm
by happys60
There is a mistake in the DTASWin engine configuration
Go to "General Engine Settings". Then "Teeth BTDC" change from 1 to 2
Re: DTA S60 start problem
Posted: Thu Mar 14, 2019 1:50 pm
by Did81
it's already set to 2
Re: DTA S60 start problem
Posted: Fri Mar 15, 2019 3:31 am
by Alex DTA
Go to Display and Test Functions -> Crankshaft Oscilloscope.
Gather the scope, and post the image here.
Re: DTA S60 start problem
Posted: Fri Mar 15, 2019 4:32 am
by Did81
Hello I have already put an image of the oscilloscope on page 1. I redo one today just in case.
Re: DTA S60 start problem
Posted: Fri Mar 15, 2019 5:33 am
by Alex DTA
Sorry, I meant when it's running.
It sounds like there are signal issues when running.
Re: DTA S60 start problem
Posted: Fri Mar 15, 2019 6:59 am
by Did81
Hello
Here are two crankshaft oscilloscpobe taken at the moment.
The first engine stopped and the second engine turned.
There is a signal problem I think ...
thank you in advance
Re: DTA S60 start problem
Posted: Sun Mar 17, 2019 1:17 pm
by Did81
good evening
The problem was found, I did not connect the case to ground on the external connection of the case.
I thought it was to fix it and not a mass.
Good night