rising edge/falling edge

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
destiny460
Posts: 20
Joined: Wed Aug 28, 2019 5:29 pm
ECU Model: S60 Pro
Distributor: Xap
Firmware Version: 86.02

rising edge/falling edge

Post by destiny460 »

Hello

little question about the front rising and falling front, I saw on the forum that it had been mentioned a moment ago
but it is not very clear I would like to have confirmation

can we modify the rising edge/ falling edge of the coils on the ecu s60 ?

thank you very much for the information
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: rising edge/falling edge

Post by Alex DTA »

Yes, you can. However, you must be careful doing this, as getting the value wrong will either damage the coil, or the ECU.

It's controlled by the "Externally Amplified Coils" option in General Engine Settings.
destiny460
Posts: 20
Joined: Wed Aug 28, 2019 5:29 pm
ECU Model: S60 Pro
Distributor: Xap
Firmware Version: 86.02

Re: rising edge/falling edge

Post by destiny460 »

ok great thank you very much
Post Reply