Xdash firmware

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
Margus Suik
Posts: 4
Joined: Thu Apr 09, 2020 12:04 pm
ECU Model: No ECU

Xdash firmware

Post by Margus Suik »

Hello

How to connect memtool to Xdash. USB,RS232 or CAN?

Thanks for the help

Margus
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Xdash firmware

Post by Alex DTA »

For any programming, use the USB connection.

To update the firmware, you will need Infineon Memtool.
If you just want to change the layout, use XConf.
Margus Suik
Posts: 4
Joined: Thu Apr 09, 2020 12:04 pm
ECU Model: No ECU

Re: Xdash firmware

Post by Margus Suik »

I have the Memtool but it is not connecting to Xdash thru USB. Port is right, dash is in programming mode.
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Xdash firmware

Post by Alex DTA »

You're holding both buttons down when powering on the XDASH?
Margus Suik
Posts: 4
Joined: Thu Apr 09, 2020 12:04 pm
ECU Model: No ECU

Re: Xdash firmware

Post by Margus Suik »

Yes
Post Reply