e48 and HEI coil/dizzy
Posted: Thu Jul 15, 2021 4:33 am
As a interim between getting the S80 onto my boat, I found my old E48 in a box over the weekend, which got me thinking...
The engine uses an ECU controlled GM/Mercruiser HEI coil and dizzy arrangement, there are loads of wires coming in and out, with quite a few communicating to the ECU.
Now, that coil has 2 plugs and at least 4 wires going to it, could it be run with the E48 and just use it as an ignition controller?
If it can, I could junk TBI until, replace with a 4 barrel thottle plate with TPS and plonk the mixer/carb directly over the inlet.
also, in the E48, when it controls the fuel pump, does it prime on ignition on, and switch off while the engine stops? I can't remember (10years +) and I couldn't find any fuel pump time control on the software.
The engine uses an ECU controlled GM/Mercruiser HEI coil and dizzy arrangement, there are loads of wires coming in and out, with quite a few communicating to the ECU.
Now, that coil has 2 plugs and at least 4 wires going to it, could it be run with the E48 and just use it as an ignition controller?
If it can, I could junk TBI until, replace with a 4 barrel thottle plate with TPS and plonk the mixer/carb directly over the inlet.
also, in the E48, when it controls the fuel pump, does it prime on ignition on, and switch off while the engine stops? I can't remember (10years +) and I couldn't find any fuel pump time control on the software.