Crank & cam sensor Buell 1125

[blownharley]

Stevie, not really. I just wanted to show the settings that got the Buell up & running.

[stevieturbo]

Ahh right...was just when you said about some pictures missing, thought there might have been a question in there somewhere.

[blownharley]

Well the bike works but I have difficulties to get it running good over 7000 rpms. When I looked at the log file I noticed a strange behaviour in the advance and injector signals, see picture below. I suspect I have some electrical noice that interferce with the signals, or what do you think?

[stevieturbo]

upload the log file...

And might be handy logging crank/cam errors etc.

And if you "load the file in reverse" on MLV, it will view the correct direction.

And is this straightforward TPS vs RPM for load, or do you have a MAP sensor in there somewhere with compensations being applied ?

[Alex DTA]

Upload a copy of your map as well.

[blownharley]

Hej Alex,

I run TPS with MAP correction for load. Forgot to add log cam and crank errors, will do this. Below you'll find the settings I use.








Will log a little bit more during the weekend including crank and cam signals.

Thanks
Peter

[Alex DTA]

Hi Peter

Please can you upload a copy of the map so I can test it here?
You can also upload the actual log data, rather than images.
If you can't upload them, or don't want to, you can email them to office@dtafast.co.uk instead.

[stevieturbo]

upload the map and log file.

And also log MAP seeing as you are using it for corrections.

[blownharley]

Attched is the map file

[blownharley]

And the log file. Unfortunately I don't have as many parameters in the log as I should. Need to get the bike up on the rolling road and get some more data recorded but since I have it outside and its rather cold here I'm a bit reluctant. Maybe I'll get some new data tomorrow?

I had to compress the file due to the size of it..