Retro fit of a PLX AFR controller into an existing S60 ecu

Discuss which Sensors work best with these ECUs and share how you are using inputs and outputs
Post Reply
vwjim
Posts: 16
Joined: Mon Nov 14, 2011 10:59 am
ECU Model: No ECU

Retro fit of a PLX AFR controller into an existing S60 ecu

Post by vwjim »

Quick question hopefully someone can verify the wiring I need to do.

My S60 DTA loom has a lambda section pre-fitted, which has Red, Black & Blue cables.

I'm fitting a PLX AFR controller, and the wiring instructions are fairly clear, but I'm not sure if I should be using the DTA Red & Black wires?

Thanks for any help.
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Retro fit of a PLX AFR controller into an existing S60 e

Post by Alex DTA »

Use the red for the PLX power, black for the PLX ground, and blue for the ECU signal. No need to add anything further.
vwjim
Posts: 16
Joined: Mon Nov 14, 2011 10:59 am
ECU Model: No ECU

Re: Retro fit of a PLX AFR controller into an existing S60 e

Post by vwjim »

Perfect Alex.

Didn't want to risk the power draw being more than the DTA catered for without checking.
Post Reply