Quick question hopefully someone can verify the wiring I need to do.
My S60 DTA loom has a lambda section pre-fitted, which has Red, Black & Blue cables.
I'm fitting a PLX AFR controller, and the wiring instructions are fairly clear, but I'm not sure if I should be using the DTA Red & Black wires?
Thanks for any help.
Retro fit of a PLX AFR controller into an existing S60 ecu
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Retro fit of a PLX AFR controller into an existing S60 e
Use the red for the PLX power, black for the PLX ground, and blue for the ECU signal. No need to add anything further.
Re: Retro fit of a PLX AFR controller into an existing S60 e
Perfect Alex.
Didn't want to risk the power draw being more than the DTA catered for without checking.
Didn't want to risk the power draw being more than the DTA catered for without checking.