Good evening,
Wondering if anyone can help...
I have had to use ANA 3 input for wide band O2 controller 0-5v input which the manual states also for oil temp input with a resistor, are there any other inputs on either the P8 or G Dash that I can do the same to input the oil temp?
Also the RPM and Alert LED I am presuming any 12v led with resistor could be used using the pin 7 +12vdc feeding them and earthed on pins 10, 11, 12 respectfully?
I also would like to run a secondary cooling water pump, which output could i use?
Thanks for any advice
Craig