Hello
Having a small problem with my analogue inputs. The manual details the ana1 value to be for conversion, ie mV to a temperature.
I have programmed the analogue 1 table for a temp sensor, and I can read the change in mV on the real time info screen, however I cannot get it to show anything other than a ana1 0.0
is there anything other than the table that I have to configure? its got me stumped
Analogue input trouble (no value displayed)
-
- Posts: 2
- Joined: Tue Feb 21, 2017 1:30 pm
- ECU Model: S60 Pro
-
- Posts: 3586
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Analogue input trouble (no value displayed)
upload your map.
And you are saying that with the engine running you get a raw and changing value for Ana1 mVolts on real time display ?
But you do not see any change on Ana1 Value ?
And you are saying that with the engine running you get a raw and changing value for Ana1 mVolts on real time display ?
But you do not see any change on Ana1 Value ?
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Analogue input trouble (no value displayed)
Make sure the ANA1 Value column is filled in, the function is active and the engine is running. The value should update then.
-
- Posts: 2
- Joined: Tue Feb 21, 2017 1:30 pm
- ECU Model: S60 Pro
Re: Analogue input trouble (no value displayed)
That's me got it working.
I didn't expect for it to only show the value when the engine was running.
with the function now enabled and the engine running it seems to work fine!
thank you
I didn't expect for it to only show the value when the engine was running.
with the function now enabled and the engine running it seems to work fine!
thank you