Analogue input trouble (no value displayed)

Discuss which Sensors work best with these ECUs and share how you are using inputs and outputs
Post Reply
cameronrsbh
Posts: 2
Joined: Tue Feb 21, 2017 1:30 pm
ECU Model: S60 Pro

Analogue input trouble (no value displayed)

Post by cameronrsbh »

Hello

Having a small problem with my analogue inputs. The manual details the ana1 value to be for conversion, ie mV to a temperature.

I have programmed the analogue 1 table for a temp sensor, and I can read the change in mV on the real time info screen, however I cannot get it to show anything other than a ana1 0.0

is there anything other than the table that I have to configure? its got me stumped
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Analogue input trouble (no value displayed)

Post by stevieturbo »

upload your map.

And you are saying that with the engine running you get a raw and changing value for Ana1 mVolts on real time display ?

But you do not see any change on Ana1 Value ?
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Analogue input trouble (no value displayed)

Post by Alex DTA »

Make sure the ANA1 Value column is filled in, the function is active and the engine is running. The value should update then.
Attachments
Ana Values.png
cameronrsbh
Posts: 2
Joined: Tue Feb 21, 2017 1:30 pm
ECU Model: S60 Pro

Re: Analogue input trouble (no value displayed)

Post by cameronrsbh »

That's me got it working.

I didn't expect for it to only show the value when the engine was running.
with the function now enabled and the engine running it seems to work fine!

thank you :)
Post Reply