Need to get some sensors for the car, Fuel, Oil, Water & oil temp plus air temp ?
Cheers Paul
Best sensors for S100 NT Dash
-
- Posts: 3586
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Best sensors for S100 NT Dash
Sensors to go to the dash direct, or to the ecu and then transmit to the dash ?
There are various part numbers mentioned for the various temperature sensors you might commonly use within the sensor calibrations.
For pressure sensors, KA Sensors would be at the more expensive range, down to cheap chinese stuff. Depends exactly what you want really.
There are various part numbers mentioned for the various temperature sensors you might commonly use within the sensor calibrations.
For pressure sensors, KA Sensors would be at the more expensive range, down to cheap chinese stuff. Depends exactly what you want really.
Re: Best sensors for S100 NT Dash
I'm after fit and forget ones don't want to be doing the job twice if you get my drift, I would assume to the ecu then dash ?
- ignitionautosport
- Posts: 577
- Joined: Wed Jul 27, 2011 5:30 am
- ECU Model: S80 Pro
- Location: New Zealand
- Contact:
Re: Best sensors for S100 NT Dash
I would normally wire to ecu so you can utilise them, and stream the data to dash.
| '94 GSR Lancer | '96 Toyota Carib 20V | '83 Toyota Starlet | www.ignitionautosport.co.nz |
-
- Posts: 3586
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Best sensors for S100 NT Dash
Again, just depends whether the ecu can take in and transmit everything you need, if not some may need to go to direct to the dash. Again depending on how much and what you want to see there.
And I'm sure Alex/DTA can sell you any sensors you'd need too.
And I'm sure Alex/DTA can sell you any sensors you'd need too.
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Best sensors for S100 NT Dash
We can supply all those sensors if needed.
Just wire them in to the ECU, and they will be available on the dash. No need for duplicates.
Just wire them in to the ECU, and they will be available on the dash. No need for duplicates.