Wideband sensor to S60 wiring
-
- Posts: 3
- Joined: Mon Nov 13, 2017 12:22 pm
- ECU Model: S60 Pro
- Distributor: Rover Dose
- Firmware Version: 79
Wideband sensor to S60 wiring
Despite searching the forum I cannot find any specifics for wiring a 5 wire wideband to an S60. The NTK has Heater + & - (switched 12v i assume). Plus a sensor ground and then VS and IP connections. Which one goes to pin 19? and what happens to the other one.
-
- Posts: 1247
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: Wideband sensor to S60 wiring
DTA can't deal directly with a wideband sensor. You need to use the Wideband driver from Inovate, PLX or whoever. This outputs 0-5v signal that the DTA can read on pin 19, referenced to sensor ground. The driver's +12v I wire in with the fuel pump so it only works when the engine is running.
-
- Posts: 3
- Joined: Mon Nov 13, 2017 12:22 pm
- ECU Model: S60 Pro
- Distributor: Rover Dose
- Firmware Version: 79
Re: Wideband sensor to S60 wiring
Thanks Rob. Got a LD one.