Wideband sensor to S60 wiring

Discuss which Sensors work best with these ECUs and share how you are using inputs and outputs
Post Reply
frenchinjection
Posts: 3
Joined: Mon Nov 13, 2017 12:22 pm
ECU Model: S60 Pro
Distributor: Rover Dose
Firmware Version: 79

Wideband sensor to S60 wiring

Post by frenchinjection »

Despite searching the forum I cannot find any specifics for wiring a 5 wire wideband to an S60. The NTK has Heater + & - (switched 12v i assume). Plus a sensor ground and then VS and IP connections. Which one goes to pin 19? and what happens to the other one.
Rob Stevens
Posts: 1247
Joined: Thu Jul 28, 2011 4:10 am
ECU Model: S100 Pro
Distributor: None-Coil On Plug :)

Re: Wideband sensor to S60 wiring

Post by Rob Stevens »

DTA can't deal directly with a wideband sensor. You need to use the Wideband driver from Inovate, PLX or whoever. This outputs 0-5v signal that the DTA can read on pin 19, referenced to sensor ground. The driver's +12v I wire in with the fuel pump so it only works when the engine is running.
frenchinjection
Posts: 3
Joined: Mon Nov 13, 2017 12:22 pm
ECU Model: S60 Pro
Distributor: Rover Dose
Firmware Version: 79

Re: Wideband sensor to S60 wiring

Post by frenchinjection »

Thanks Rob. Got a LD one.
Post Reply