It is currently Tue Oct 16, 2018 9:42 am



Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: NT-Dash fuel level settings
PostPosted: Mon Aug 13, 2018 1:14 pm 
Offline

Joined: Thu Jul 28, 2011 4:10 am
Posts: 852
ECU Model: S100 Pro
Try a smaller resistor, perhaps 200ohm


Top
 Profile  
 
 Post subject: Re: NT-Dash fuel level settings
PostPosted: Tue Aug 14, 2018 4:59 am 
Offline

Joined: Fri Feb 28, 2014 1:03 pm
Posts: 1116
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79
There are two ways.

In the data table, use the gain and offset values to modify the raw voltage to fuel level.
The formula is Fuel Level = (Gain * mV) + Offset.

Easier for you would be to use the thresholds.
Set the Conv to "By Part" and enter the Threshold values. X is mV, Y is fuel level.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Theme designed by stylerbb.net © 2008
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
All times are UTC - 5 hours