NT-Dash fuel level settings

Discuss which Sensors work best with these ECUs and share how you are using inputs and outputs
Rob Stevens
Posts: 1247
Joined: Thu Jul 28, 2011 4:10 am
ECU Model: S100 Pro
Distributor: None-Coil On Plug :)

Re: NT-Dash fuel level settings

Post by Rob Stevens »

Try a smaller resistor, perhaps 200ohm
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: NT-Dash fuel level settings

Post by Alex DTA »

There are two ways.

In the data table, use the gain and offset values to modify the raw voltage to fuel level.
The formula is Fuel Level = (Gain * mV) + Offset.

Easier for you would be to use the thresholds.
Set the Conv to "By Part" and enter the Threshold values. X is mV, Y is fuel level.
Post Reply