Page 2 of 2
Re: NT-Dash fuel level settings
Posted: Mon Aug 13, 2018 1:14 pm
by Rob Stevens
Try a smaller resistor, perhaps 200ohm
Re: NT-Dash fuel level settings
Posted: Tue Aug 14, 2018 4:59 am
by Alex DTA
There are two ways.
In the data table, use the gain and offset values to modify the raw voltage to fuel level.
The formula is Fuel Level = (Gain * mV) + Offset.
Easier for you would be to use the thresholds.
Set the Conv to "By Part" and enter the Threshold values. X is mV, Y is fuel level.