Can anyone confirm that its just two connections as per pager 6 on the TTT Racing PDF
As in pin 33 and 14 on a S100 but the sensor has 3 wires +ve 0v and output !!
http://www.ttt-racing.com/doc/ECUTTT802E.pdf
Cheers Paul
Tractive Gearbox TTT Racing flatshit wiring S100
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Tractive Gearbox TTT Racing flatshit wiring S100
Are you using a TTT802? If so, what are you trying to achieve?
Re: Tractive Gearbox TTT Racing flatshit wiring S100
Hi Alex I’m having the flatshift sensor for flatshift as a back up with the gear pot incase either goes belly up ?
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Tractive Gearbox TTT Racing flatshit wiring S100
The ECU can only be set up to accept one at a time.
Page 6 is correct.
The gear pot will be connected to the TTT unit, and there will be an output from there that tells the ECU a shift is happening.
If you want to connect a gear pot to both the ECU and the TTT unit, which you will need if you run both units, you will need to get a dual output potentiometer.
Page 6 is correct.
The gear pot will be connected to the TTT unit, and there will be an output from there that tells the ECU a shift is happening.
If you want to connect a gear pot to both the ECU and the TTT unit, which you will need if you run both units, you will need to get a dual output potentiometer.