SR20DE trigger
SR20DE trigger
hi has anyone used the AEM trigger disc 24-1 instead of the OE 360 if so was it more reliable at high rpm and how did you set it up ? many thanks
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: SR20DE trigger
They work well.
Not sure on the TDC angle with those, but if you post another crank scope with all spark plugs removed except cylinder 1, we can get that sorted.
Not sure on the TDC angle with those, but if you post another crank scope with all spark plugs removed except cylinder 1, we can get that sorted.
Re: SR20DE trigger
thanks
completely removed or disconnected ?
heres one with them disconnected
completely removed or disconnected ?
heres one with them disconnected
Re: SR20DE trigger
is it a case of just moving the sensor position in general settings with the timing light on ?
-
- Posts: 3587
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: SR20DE trigger
removed obviously, so cyl1 can be identified.
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: SR20DE trigger
If you're close enough that it will run, then that's all you need to do.Silbeam wrote:is it a case of just moving the sensor position in general settings with the timing light on ?
If not, then remove the spark plugs from the engine, not just disconnect them.
Re: SR20DE trigger
do I need to use a different trigger mode or still use mode 8 but change the trigger count to 24 and coil teeth to 1 ?
Re: SR20DE trigger
one more question can you lock timing anywhere with out changing the map to set up timing ?