I am building a Jaguar 3.0 V6 with Piper camshafts, the original cams have a sensor on the end of each inlet cam
I intend to swap one of the sensors onto a piper inlet cam, consequently I can position the sensor anywhere + or - 360 of TDC
Is there an optimum position for the cam sensor in relation to tdc
Cam sensor position
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Cam sensor position
As long as it is not near TDC, that is fine.
If you are using VVT, then also make sure the sensor cannot cross over TDC
If you are using VVT, then also make sure the sensor cannot cross over TDC