Newbie Question Common grounding?
-
- Posts: 20
- Joined: Sat Mar 17, 2012 10:31 am
- ECU Model: S60 Pro
- Firmware Version: 62
- Location: Bury St Edmunds, Suffolk UK
Newbie Question Common grounding?
Are the SENSOR GND terminals connected at some stage to the POWER GND at any point? Its not shown in the manual as connected or is there any harm done in connecting Sensor GND to Power GND
turn right.... go fast.... turn right
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: Newbie Question Common grounding?
If you are concerned about inadvertent grounding of a sensor ground it's not the end of the world but try and avoid it. They are connected internally according to my meeter but there may be some special gizmo in there also?
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Newbie Question Common grounding?
Internally yes they will all be connected.
But as long as all grounds are good and not scattered all over the place you should be fine.
What sensor are you looking to wire to the power ground ?
But as long as all grounds are good and not scattered all over the place you should be fine.
What sensor are you looking to wire to the power ground ?