Yet another crank sensor problem!
-
- Posts: 43
- Joined: Mon May 16, 2016 8:01 am
- ECU Model: S60 Pro
- Distributor: Kl racing
- Location: Norway
Re: Yet another crank sensor problem!
hi martin do you know the number on that fiat sensor??
Living life sideways
- mefmotorsport
- Posts: 543
- Joined: Mon Aug 01, 2011 6:45 am
- ECU Model: S100 Pro
- Distributor: Mefmotorsport
- Firmware Version: 79
- Location: Merseyside
- Contact:
Re: Yet another crank sensor problem!
I'll ask my mate if he has the part number
-
- Posts: 38
- Joined: Sat Jul 30, 2011 4:35 pm
- ECU Model: S100 Pro
- Distributor: JON-TEC-RALLYE
- Firmware Version: 89
- Location: Canary-Island
Re: Yet another crank sensor problem!
for such a small diameter I used a wheel 36-1. curiously also a sensor fiat, I have had good results, until 9400rpm plus or minus from there the signal was lost and the ecu stopped sending signals, the signal is saturated, the separation 0.3mm. the sensor if I remember correctly is a FIAT PANDA 96, has two screws to hold it and a long cable.
another that resembles it, so fine in the end, is the dta recommended in your manual ford
another that resembles it, so fine in the end, is the dta recommended in your manual ford
DTA--MoTec--Link--Ecumaster--HONDATA
- mefmotorsport
- Posts: 543
- Joined: Mon Aug 01, 2011 6:45 am
- ECU Model: S100 Pro
- Distributor: Mefmotorsport
- Firmware Version: 79
- Location: Merseyside
- Contact:
Re: Yet another crank sensor problem!
I just found out that the Fiat sensor came from a Stilo active model from 2003 1242cc and the vrn of the car it came from in the breakers yard was PJ53UWK so if someone can ask on a motor factors shop and give that vrn then it should reveal the part number.
-
- Posts: 43
- Joined: Mon May 16, 2016 8:01 am
- ECU Model: S60 Pro
- Distributor: Kl racing
- Location: Norway
-
- Posts: 43
- Joined: Mon May 16, 2016 8:01 am
- ECU Model: S60 Pro
- Distributor: Kl racing
- Location: Norway