Goodday, This might be a stupid question but i'm gonna ask it anyway.
My 2JZ is equipped with an oil pressure, oil temperature & water temperature gauge. Would it be possible to use these also for the DTA or do they require separate sensors? It would be strange to run 2 oil pressure pods i suppose.
best regards,
Sharing sensors with gauges.
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Sharing sensors with gauges.
You MIGHT be able to share the oil pressure, but you cannot share the temperature sensors.
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Sharing sensors with gauges.
For then most part....a 3 wire powered sensor can be shared.
2 wire resistive....not so easily.
2 wire resistive....not so easily.
Re: Sharing sensors with gauges.
Thank's for the advise guys!.
Re: Sharing sensors with gauges.
Just made a secont temperature sensor for the oil temperature. I'd really rather not fit an extra pressure pod. Saw in the settings that the oil pressure input voltage goes to 5v. Guess the gauge would be 12. Would the extra voltage be harmfull for my sensor input on the S80?
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Sharing sensors with gauges.
Why would you guess a gauge goes to 12v ?
Dont even mention what gauge or setup it is ?
Dont even mention what gauge or setup it is ?