CAN Communication

gnutz2 · Post by **gnutz2** » Sun Oct 25, 2015 2:55 pm

Anyone got a can to USB converter working?

Would this do the job?

http://www.ebay.co.uk/itm/USB-CAN-USB-t ... zcfqCaRPRA

stevieturbo · Post by **stevieturbo** » Sun Oct 25, 2015 3:23 pm

Unless you're able to program that with DTA's comms protocols/datastreams for CAN....I'm not sure it will be of any use ?

gnutz2 · Post by **gnutz2** » Mon Oct 26, 2015 11:35 am

Oh, I naively assumed that nothing would need programming.

Anyone on the forum done this?

bofelix · Post by **bofelix** » Tue Oct 27, 2015 6:37 am

Hello,

yes I did for the connection to DTASwin. It is much more faster than standard connection.

I have found a new SYSTEC Can to USB controller here in Germany at Ebay for a really low price. The Systec CAN-software must be installed (USB driver).

The China connector you have posted could word, but I don't know...

DTASwin checks at start, if CAN is connected. An then the software uses CAN connection.

Just use the Forum search function. Type 'systec' an you will find the post.
Here is the link:
viewtopic.php?f=8&t=553&hilit=systec

cheers
Stefan

Alex DTA · Post by **Alex DTA** » Tue Oct 27, 2015 11:10 am

Systec is the one we sell and use for our development.

Not tried the other one.

gnutz2 · Post by **gnutz2** » Wed Oct 28, 2015 2:10 pm

Do these devices need a lot of setting up, software wise. Or are they more plug and play?

Alex DTA · Post by **Alex DTA** » Wed Oct 28, 2015 5:36 pm

Plug and play. You just need the CAN output from the ECU

DTAForum.com - a forum for the DTA ECU

CAN Communication

CAN Communication

Re: CAN Communication

Re: CAN Communication

Re: CAN Communication

Re: CAN Communication

Re: CAN Communication

Re: CAN Communication