Hi, I made my own box and its working fine.
Have one question, The manual dosent say
While mapping, when i fine tune and hit enter on the box when i am happy with the result, the adjustment i stored in the cell right? If the adjustment was ex 5% will that 5% be added to the same cell again? so that i must hurry and adjust it back to zero% ?
OR will that 5% be added again first when i move on to the next cell
Thanks
Using te box in real time mapping
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Using te box in real time mapping
The addition is based on the original map, so when you press enter, the software stores the 5% change, not the ECU.
So you can adjust that cell 5%, press enter, then adjust it to 6%, press enter, then adjust it to 4%, press enter. Only the 4% will be saved.
When you move to the next cell, the 5% will be added to that cell as well.
So you can adjust that cell 5%, press enter, then adjust it to 6%, press enter, then adjust it to 4%, press enter. Only the 4% will be saved.
When you move to the next cell, the 5% will be added to that cell as well.
Re: Using te box in real time mapping
Ok thanks, i think i got it now