It is currently Mon Oct 15, 2018 8:00 am



Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: turbo control setting
PostPosted: Thu Jan 18, 2018 12:47 pm 
Offline

Joined: Thu Jan 18, 2018 12:35 pm
Posts: 2
ECU Model: S80 Pro
Hello,

I have installed in a MAC solenoid valve to manage the boost.
But I can not manage the pressure.
I'm going systematically in the overboost limit.
How is the parrametre?
I have a MAP / regime management.
Thank.


Attachments:
gremlins1.map [44.97 KiB]
Downloaded 66 times
Top
 Profile  
 
 Post subject: Re: turbo control setting
PostPosted: Thu Jan 18, 2018 1:01 pm 
Offline

Joined: Fri Feb 28, 2014 1:03 pm
Posts: 1116
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79
You have no base PWM set up, and only a 30 kPa difference between target boost and overboost.

Turn off closed loop, and set up the base PWM to give approximately the correct boost.
Then turn on closed loop, and fine tune.


Top
 Profile  
 
 Post subject: Re: turbo control setting
PostPosted: Thu Jan 18, 2018 1:23 pm 
Offline

Joined: Thu Jan 18, 2018 12:35 pm
Posts: 2
ECU Model: S80 Pro
I have the wastegate which starts at 150 Kpa (except in 5 or I go up to 170). So to get 180 everywhere, I filled the PWM table at 20%, I remlpi the target pressure table to 180, an overboost to 220, I will not have to exceed 180.

I thought the target was enough to control
thank


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Theme designed by stylerbb.net © 2008
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
All times are UTC - 5 hours