Using te box in real time mapping

Give input on tuning as well as any tips and tricks you may have. Also feel free to share base mapping files for various engine types.
Post Reply
maxiice
Posts: 67
Joined: Sat Apr 13, 2013 5:16 pm
ECU Model: S80 Pro
Firmware Version: 63

Using te box in real time mapping

Post by maxiice »

Hi, I made my own box and its working fine.

Have one question, The manual dosent say

While mapping, when i fine tune and hit enter on the box when i am happy with the result, the adjustment i stored in the cell right? If the adjustment was ex 5% will that 5% be added to the same cell again? so that i must hurry and adjust it back to zero% ?

OR will that 5% be added again first when i move on to the next cell

Thanks :)
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Using te box in real time mapping

Post by Alex DTA »

The addition is based on the original map, so when you press enter, the software stores the 5% change, not the ECU.
So you can adjust that cell 5%, press enter, then adjust it to 6%, press enter, then adjust it to 4%, press enter. Only the 4% will be saved.

When you move to the next cell, the 5% will be added to that cell as well.
maxiice
Posts: 67
Joined: Sat Apr 13, 2013 5:16 pm
ECU Model: S80 Pro
Firmware Version: 63

Re: Using te box in real time mapping

Post by maxiice »

Ok thanks, i think i got it now :)
Post Reply