DTAForum.com - a forum for the DTA ECU
http://dtaforum.com/

Using te box in real time mapping
http://dtaforum.com/viewtopic.php?f=7&t=1542
Page 1 of 1

Author:  maxiice [ Fri Aug 31, 2018 2:36 pm ]
Post subject:  Using te box in real time mapping

Hi, I made my own box and its working fine.

Have one question, The manual dosent say

While mapping, when i fine tune and hit enter on the box when i am happy with the result, the adjustment i stored in the cell right? If the adjustment was ex 5% will that 5% be added to the same cell again? so that i must hurry and adjust it back to zero% ?

OR will that 5% be added again first when i move on to the next cell

Thanks :)

Author:  Alex DTA [ Fri Aug 31, 2018 2:44 pm ]
Post subject:  Re: Using te box in real time mapping

The addition is based on the original map, so when you press enter, the software stores the 5% change, not the ECU.
So you can adjust that cell 5%, press enter, then adjust it to 6%, press enter, then adjust it to 4%, press enter. Only the 4% will be saved.

When you move to the next cell, the 5% will be added to that cell as well.

Author:  maxiice [ Fri Aug 31, 2018 4:55 pm ]
Post subject:  Re: Using te box in real time mapping

Ok thanks, i think i got it now :)

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/