This is what I mean, which I don't understand. Shouldn't the turbo target pressure table be TPS vs RPM, regardless of the user selecting TPS or MAP as load?
turbo target pressure map
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: turbo target pressure map
Ahh yes...that doesnt make a lot of sense.
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: turbo target pressure map
@stevieturbo, TRN isn't talking about the base PWM table, he's talking about the turbo target table, where the values are a boost target.
@TRN I think you have a box ticked that you shouldn't. Turbo target should have RPM as it's Y axis, and TPS as it's X-axis. In Turbo Parameters, make sure the option "Use MAP for PWM X Axis" is not ticked.
@TRN I think you have a box ticked that you shouldn't. Turbo target should have RPM as it's Y axis, and TPS as it's X-axis. In Turbo Parameters, make sure the option "Use MAP for PWM X Axis" is not ticked.
Re: turbo target pressure map
Damn you are good - I was just about to point the OP there!
Re: turbo target pressure map
Yes that solved it! Thanks again!!
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: turbo target pressure map
Software glitch then that allows this to happen ?Alex DTA wrote:@stevieturbo, TRN isn't talking about the base PWM table, he's talking about the turbo target table, where the values are a boost target.
@TRN I think you have a box ticked that you shouldn't. Turbo target should have RPM as it's Y axis, and TPS as it's X-axis. In Turbo Parameters, make sure the option "Use MAP for PWM X Axis" is not ticked.