Dies over 2000rpm

Give input on tuning as well as any tips and tricks you may have. Also feel free to share base mapping files for various engine types.
Post Reply
postal
Posts: 5
Joined: Sat Mar 17, 2012 2:24 pm
ECU Model: S80 Pro

Dies over 2000rpm

Post by postal »

Hi

I have a problem with my S80
when it comes over 2000rpm and it switches on the COP then the engine dies
had it running in a test bench, a working fine. Now installed in the car and now the problem is there.
I tested the cables 5 times and not found some errors.
If I disconnect the plug from the cam sensor, it can not start
Attached map and log

hope there are some who can help me :-(

Spec.
cosworth YB
cop
cam sensor
8 inj.
turbo
3DR cosworth.map
Map
(43.12 KiB) Downloaded 261 times
log.Dat
Log
(873.77 KiB) Downloaded 251 times
Image
Jon K
Posts: 602
Joined: Fri Dec 04, 2009 1:45 am
ECU Model: S80 Pro
Distributor: DTA UK
Firmware Version: 73
Location: Pennsylvania, USA
Contact:

Re: Dies over 2000rpm

Post by Jon K »

I had a similar issue - my cam sensor angle was wrong
1992 700RWHP Pump Gas BMW
Image
postal
Posts: 5
Joined: Sat Mar 17, 2012 2:24 pm
ECU Model: S80 Pro

Re: Dies over 2000rpm

Post by postal »

Where to adjust this :-)
VR6Turbo
Posts: 329
Joined: Wed Mar 17, 2010 9:24 am
ECU Model: S80 Pro
Firmware Version: 62

Re: Dies over 2000rpm

Post by VR6Turbo »

How many teeth does your cam sensor trigger wheel have? If more than 1, you will need to use a different flywheel mode.

With the engine running, have a look in the diagnostics page and it will tell you the cam sensor position in the bottom right corner. Take that number and put it in the Sequential settings map. Yours is currently set to 0.
postal
Posts: 5
Joined: Sat Mar 17, 2012 2:24 pm
ECU Model: S80 Pro

Re: Dies over 2000rpm

Post by postal »

Thanks I will try it :-)
postal
Posts: 5
Joined: Sat Mar 17, 2012 2:24 pm
ECU Model: S80 Pro

Re: Dies over 2000rpm

Post by postal »

just what was needed
thank you

:-D
Post Reply