Hi
I have a problem with my S80
when it comes over 2000rpm and it switches on the COP then the engine dies
had it running in a test bench, a working fine. Now installed in the car and now the problem is there.
I tested the cables 5 times and not found some errors.
If I disconnect the plug from the cam sensor, it can not start
Attached map and log
hope there are some who can help me
Spec.
cosworth YB
cop
cam sensor
8 inj.
turbo
Dies over 2000rpm
-
- Posts: 602
- Joined: Fri Dec 04, 2009 1:45 am
- ECU Model: S80 Pro
- Distributor: DTA UK
- Firmware Version: 73
- Location: Pennsylvania, USA
- Contact:
Re: Dies over 2000rpm
I had a similar issue - my cam sensor angle was wrong
1992 700RWHP Pump Gas BMW
Re: Dies over 2000rpm
Where to adjust this
Re: Dies over 2000rpm
How many teeth does your cam sensor trigger wheel have? If more than 1, you will need to use a different flywheel mode.
With the engine running, have a look in the diagnostics page and it will tell you the cam sensor position in the bottom right corner. Take that number and put it in the Sequential settings map. Yours is currently set to 0.
With the engine running, have a look in the diagnostics page and it will tell you the cam sensor position in the bottom right corner. Take that number and put it in the Sequential settings map. Yours is currently set to 0.
Re: Dies over 2000rpm
Thanks I will try it
Re: Dies over 2000rpm
just what was needed
thank you
thank you