Opening the ECU unit

Discuss issues and tuning software like DTASWin, E-Race, MegaLogViewer(DTA), etc. Also post archive versions of firmware.
Post Reply
tzei
Posts: 29
Joined: Thu Oct 06, 2011 3:01 am
ECU Model: S60 Pro
Firmware Version: 71

Opening the ECU unit

Post by tzei »

Hi all

So my ECUs serial connector losed one of its small tighening nuts - one of the two that rs cable fastenings go for. I might do with just one but thing is that -eh- bolts head is just visible and flush with encasing. I really like to adress that so hence the question:

What i need to know to open, fix serial port fastening and put it back to gether with success? Thought that i'll ask before...

My fear is that the bolt inside works its way to fully loose and causes havoc inside.
MarcoV6T
Posts: 101
Joined: Tue Jul 26, 2011 12:20 pm
ECU Model: S80 Pro
Firmware Version: 58

Re: Opening the ECU unit

Post by MarcoV6T »

I would say, loosen the screws and see... But be careful with the sealing gasket.

The only thing; if it's still under warranty, I wouldn't do it, ship it back.
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Opening the ECU unit

Post by Alex DTA »

tzei wrote:My fear is that the bolt inside works its way to fully loose and causes havoc inside.
There is no bolt on the inside. Just refit a standard bolt to the outside and you'll be fine.
Don't take it apart, you'll break the seals on the case, and the ones on the screws.
Post Reply