I've lost the fuel and ignition maps, they are ticked in the display options but not on screen, I've uninstalled and reinstalled but to no avail, all the other setting appear if ticked?
I've tried it on another laptop and the ignition is visible but not the fuel.
I thought it could be a display setting on the laptop so looked at that to,
Help needed with real time mapping page
-
- Posts: 52
- Joined: Fri May 04, 2012 2:51 pm
- ECU Model: P8 Pro
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: Help needed with real time mapping page
Try loading the display settings again
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Help needed with real time mapping page
Is this DTAWin for an E48/P8?
They're either behind one of the other screens (very small), or they've been dragged to a part of the screen that can't be seen.
I can send over a screen settings in the morning for you.
They're either behind one of the other screens (very small), or they've been dragged to a part of the screen that can't be seen.
I can send over a screen settings in the morning for you.
-
- Posts: 52
- Joined: Fri May 04, 2012 2:51 pm
- ECU Model: P8 Pro
Re: Help needed with real time mapping page
I think I've sorted it, I found a sample screen display and loaded that, off line so as Long as when I connect to the ecu I can load that sample then I'm good,
Thanks very much for your help
Thanks very much for your help